Помогите разобраться с ошибками. Машина а класс 170 бензин АКПП вариатор. Пропадают PRND с приборной панели...когда их нету, то машина не заводится, а когда есть, заводится...но едет постоянно в аврийном режиме и больше 2500 на тахометре не поднимает. Ошибки такие:
Petrol (266.940 - SIM266 - MT/AT - 169.032/332)
DTC Description
00AA70 - Unknown fault code
006F81 - Unknown fault code
00F871 - Unknown fault code
00F681 - Unknown fault code
00BB - Implausible engine torque requested by ETC control module
- Permanent
Brake (ESP (Electronic Stability Program) - ESP169 (Electronic Stability
Program) - MT/AT)
DTC Description
631F - No CAN message was received from control unit gearbox
- Intermittent
5331 - CAN-signal
- Intermittent
Instrument (Instrument - Instrument - MT/AT)
DTC Description
9103 - Can communication with EGS
- Intermittent
Gearbox (Gearbox - FCVT (CVT gearbox; (Continuously variable automatic transmission)) - AT)
DTC Description
C121 - No or incorrect CAN message from ESP and BAS control module
- Permanent
C100 - One or more messages from engine control unit are not available on the CAN bus
- Permanent
26381 - Unknown fault code
D10B - One or more messages from engine control unit are not available on the CAN bus
- Permanent
C103 - One or more messages from electronic selector lever module are not available on the CAN bus
- Permanent
C155 - No or incorrect CAN message from control unit Instrument cluster
- Permanent
C126 - One or more messages from steering column module and (or) from electronic selector lever module are not available on the CAN bus
- Permanent
C164 - CAN message from control module AAC/TAC
- Permanent
C141 - One or more messages from engine control unit are not available on the CAN bus
- Permanent
0895 - Impermissible adjustment of the step-up ratio
- Permanent
C0011 - Unknown fault code
D508 - CAN: communication fault with ESM (Electronic Selector Module)
- Permanent
0894 - Steel thrust belt; slipping
- Permanent
Multifunction (Power steering - ES (Electrical power steering) - MT/AT)
DTC Description
5501 - CAN communication with other control units installed in this vehicle is not possible
- Intermittent
5521 - One or more messages from engine control unit are not available on the CAN bus
- Intermittent
5542 - Steering torque request signal transmitted by ESP and BAS control module is implausible
- Intermittent
Multifunction (Roof contr. - RCM (Roof control module) - MT/AT)
DTC Description
9001 - The supply voltage of the control unit is too low (undervoltage).
Multifunction (Steering wheel electronics - SCCM (Steering column module) - MT/AT)
DTC Description
9348 - CAN: communication engine
- Intermittent
Спасибо за помощь.
диагностику найдите нормальную Стар диагнос , а эти цыфры не о чем не говорят